CSH-GARAGEOPN: Installing the Smart Garage Door Opener

Question: How do I install the CSH-GARAGEOPN Smart Garage Door Opener?

Answer:
Follow the detailed steps below to install your CSH-GARAGEOPN Smart Garage Door Opener successfully:

Step 1: Check Compatibility

1. Before starting the installation, check if your garage door is compatible:

• Check the compatibility list Attached Below
• Alternatively, test manually:
  • Find the terminals connected to your wall-mounted button.
  • Use a wire or pliers to place ends on the same terminals. If the garage door opens, it’s compatible. If not, it's incompatible.

Image: Compatibility Test

Step 2: Installing the Door Sensor

2.1. Clean the Surface:

• Close your garage door.
• Clean the surface of the top panel where the door sensor will be installed.

2.2. Install the Sensor:

• Use the double-sided adhesive tape to attach the sensor to the cleaned area on the top panel of the garage door. Ensure the sensor is securely attached for accurate operation.

Note: The sensor will only work properly if placed on the top panel of your garage door.

Image: Sensor Installation Instructions

Step 3: Pairing the Sensor with the Controller

3.1. Confirm Sensor Status:

• Check that the LED indicator is flashing blue before pairing.

3.2. Place the Sensor:

• Position the sensor on a flat surface, vertically or horizontally, before installing it.
• 
• After approximately 15-20 seconds, the app should display the correct state of the door (open/closed).

Image: Pair Sensor and Controller

Step 4: Installing the Smart Controller

4.1. Power Off the Garage Door Opener:

• Make sure the opener is turned off before connecting any cables.

4.2. Connect the Controller Cables:

• Attach the controller’s cables to the same terminals connected to the wall-mounted button.

Image: Controller Connection Diagram

Step 5: Pairing the Controller with Wi-Fi and the App

5.1. Download and Install the Connect SmartHome App:

• Download the Connect SmartHome App from the Google Play Store or Apple App Store.
• Register or log in to your account.

5.2. Pair the Controller:

• Ensure the controller is plugged in and hold the pairing button for 5 seconds until the LED flashes red rapidly.
• Open the app and add the Garage Door Opener from the "Electrical" category.
• Follow the on-screen prompts to connect the device to your 2.4GHz Wi-Fi.

Image: Wi-Fi Pairing

Step 6: Test the Opener

6.1. Perform Test:

• Open and close the garage door 3-5 times using the app to check for proper function.
• If the sensor and door status display incorrectly, recheck sensor placement and pairing.

Step 7: Set Up Automations in the App (Optional)

7.1. How to Automate Scenes:

• Use the app to add the device to either a “Condition” list (triggering another smart device when the door opens/closes) or an “Action” list (automatically close the door based on conditions like weather).

Image: Automation Setup